Dynapac CA 302, Instruction Manual

Page: 53 / 121

Operation
ICA302-4EN4.pdf 2012-04-12
Instruments and lamps - Checking
31 1
10
15
26
28 16
27
Fig. Instrument panel
1. Starter switch
10. Voltmeter (Optional)
15. Fuel gauge
16. Preheating lamp
26. Hourmeter
27. Brake lampa
28. Oil pressure lamp
31. Charging lamp
Turn the switch (1) to the mid-position. All warning
lamps should light for about 5 seconds and the beeper
should sound.
During this time check that the warning lamps light up.
Check that the voltmeter (10) reads at least 12 volts,
and that the fuel gauge (15) shows a reading.
Check that the warning lamps for charging (31), oil
pressure (28), and the parking brake (27) come on.
The hourmeter (26) registers and shows the number of
hours the diesel engine has been running.
The preheating lamp (16) must go on.
Parking brake - Check
42
Fig. Control panel
42. Parking brake knob
Make sure that the parking brake knob (42) is in
activated position. The roller can start to roll when
the engine is started on sloping ground, if the
parking brake is not activated. Make sure that the parking brake knob (42) is in
activated position. The roller can start to roll when
the engine is started on sloping ground, if the
parking brake is not activated.
43