Dynapac CA 302, Instruction Manual

Page: 107 / 121

Maintenance - 500h
ICA302-4EN4.pdf 2012-04-12
Diesel engine - Oil and Filter change
Fig. Left side of engine
1. Drain plug
2. Oil filter
1
2
Take great care when draining warm fluid and oil.
Wear protective gloves and goggles. Take great care when draining warm fluid and oil.
Wear protective gloves and goggles.
The oil drain plug (1) is most easily accessible from
the bottom of the engine and is located attached to a
hose on the rear axle.. Drain the oil when the engine is
warm. Place a receptacle that holds at least 15 liters
(4 gal) under the drain plug.
Replace the engine oil filter (2) at the same time. Refer
to the engine manual.
Deliver the drained oil and filter to
environmentally correct handling. Deliver the drained oil and filter to
environmentally correct handling.
Steering chain and seat bearing - Lubrication
Fig. Underneath operator's position
1. Steering chain
2. Chain-tightening device
3. Adjusting nut
4. Nuts
5. Control valve mount
1
2
3
4
5
a
Optional on rollers without cab
Keep in mind that the chain is a vital part of the
steering mechanism. Keep in mind that the chain is a vital part of the
steering mechanism.
Clean and lubricate the chain (1) between the seat
bearing and steering valve with grease. The chain can
be accessed from underneath the operator's position.
It is not necessary to remove the chain.
Adjust the chain as follows if it has slackened so that
size "a" is less than 30 mm (1.2 in): Loosen the nuts
(4) and adjust the mount (5) backwards with the
adjusting nut (3) until size "a" is 50 mm (2 in).
97