3.1.2 Installation and wiring
(1) Disassembly the camera for installation
(2) Inside of the back box for installation
Please be careful to wrong connect so that it is explained each connector of function as below
picture.
Figure 4. WIRING PART OF THE BACK BOX
Figure 2. DISASSEMBLY THE DOME
First, loose the dome drive from the back
box.
Loose first, the dome drive from the back
box.
Loose the bolt on the side of cover with a
screw driver and it could be removed lower
bubble.
Remove the dome drive from back box.
There are 3 bolts on the body of camera.
They should not full pulled out to prevent
missing.
Loose three of round-headed bolts from the
dome drive. It can be out up to about 1cm to
prevent missing after loosen all.
Loose the all of bolts and then pull up the lip of
the dome drive with both hands.
Remove the dome drive from back box.
If you unscrew one of
bolt (with
'
+
'
screw
driver) on the
connector cover, it is
opened.
Open the connector cover.
Please connect Data, Power
and Video cables.
Figure 3.
Plug in one end of (-) RS-485 data cable.
Plug in one end of (+) RS-485 data cable.
Plug in one end of output (24Vac) from the
power supply.
Plug in one end of video signal cable.