3URJUDPPLQJ
54
Ô
)RUQRQVHUYRVWHHUHG';6\VWHPV303030
Select a Veer Compensation value so that the wheelchair does not veer when
the joystick is pushed directly forwards or backwards. If the wheelchair veers
right, press ‘LEFT’; if the wheelchair veers left, press ‘RIGHT’.
)RUVHUYRVWHHUHGWZRGULYHPRWRU';6\VWHPV303030
Use an ammeter to measure the current to each drive motor. Select a Veer
Compensation value so that the current to the left drive motor is equal to the
current to the right drive motor when the wheelchair is driven in a straight line.
Use the SLM Veer Compensation to correct any veer.
Selecting the correct value will require experimentation. Adjust the Veer
Compensation value then test drive the wheelchair.
Refer to the Saving Changes section.
6HWWLQJ/RDG&RPSHQVDWLRQ
Warning:
It is essential for safety and performance that the Load Compensation
be set to the manufacturer’s recommended value for the wheelchair type to be used
in the DX System.
1.
Enable the Technician Mode
2.
Press 'NEXT’ in the main menu until the screen reads :
* * MAIN MENU * *
View or edit Power
Module ? (Tech Only)
NEXT
YES
Press 'YES'.
Pressing ‘EXIT’ at any point during the calibration procedure will return you
to screen
.
Ô
Summary of Contents for DX Power Module PMB
Page 5: ...Contents ...