7HVWLQJ
32
7HVWLQJ
The following procedure should be carried out in a spacious environment and with
due regard to possible unexpected wheelchair movement in the event of faulty
installation.
1.
Raise the wheels off the ground using blocks under the wheelchair frame, so
that the wheels can turn freely.
2.
Recheck all wiring, paying particular attention to polarities of batteries,
motors and Park Brakes.
3.
Make the final connection to the B terminal, then close the circuit
breakers.
4.
The DX Remote will have one or more buttons or switches for turning on
the DX System. Refer to the appropriate DX Remote Installation Manual to
identify the switch(es) and procedure to turn the system on and off.
Turn on the DX System and check that the DX Remote powers up correctly
- see the appropriate DX Remote Installation Manual for the normal
response.
Note :
The first time the DX Remote is turned on the System Status Led will
flash a fault. This is because the DX Remote must download its information to the
DX Power Module. Wait 10 seconds before turning the DX Remote off, wait 10
seconds, then turn it back on to clear this fault. Refer to the Auto Download
section.
5.
Check that the Power Module’s Green Status LED is on steady. If this is still
flashing the PM may be faulty. Refer to the Diagnostics section.
6.
Try turning each driving wheel by hand to check that the Park Brakes are
engaged. The wheels should not move.
7.
Push the joystick slightly out of neutral and listen for the “click” as the park
brakes disengage.
8.
Move the joystick in all directions and ensure that the wheels respond
smoothly and in the correct direction. Repeat for all Drive Programs.
Summary of Contents for DX Power Module PMB
Page 5: ...Contents ...