3URJUDPPLQJ
36
Warning :
When a DX Remote is replaced, it will perform an Auto Download
of the DX Power Module programming. This may result in incorrect and dangerous
programming for a particular wheelchair system if the wheelchair program installed
in the DX Remote is not suitable for that wheelchair system.
When replacing a DX Remote, use the HHP and / or Wizard to ensure that the DX
Power Module parameters are programmed correctly for the wheelchair type.
After replacing a Module, turn the DX System off, wait 10 seconds, then turn on
again to initiate the Auto Download of the DX Remote backup data.
When an Auto Download has occurred, but the system needs to be cycled on and
off, a Module Fault (Flash Code 1) is displayed on the DX Remote’s System Status
LED. When the System is turned off then on again, the fault is cleared and the
Auto Download is correctly terminated.
Summary of Contents for DX Power Module PMB
Page 5: ...Contents ...