3URJUDPPLQJ
38
';++3
The DX Hand Held Programmer (HHP) is the normal programming tool used by
dealers, allowing easy adjustment of all commonly adjusted Drive Program
parameters.
Warning :
The DX-HHP is for use only by wheelchair manufacturers and their
authorised dealers. It is not for use by the wheelchair user. Dealers may only
program parameters as instructed by the wheelchair manufacturer.
The DX-HHP Manual should be read and understood before attempting to use the
HHP.
30:L]DUG3URJUDPPLQJ
,QWURGXFWLRQ
It is the combination of a DX Remote and a PM which define overall driving
performance. Both modules have associated parameters which affect wheelchair
performance and which must be considered together to get the best driving
performance.
Most of the parameters that need to be set up on an individual wheelchair basis to
suit the needs of particular users (e.g. the Drive Programs) are associated with the
DX Remote and are described in the DX Remote Installation Manual.
Most of the parameters that are set up for a particular wheelchair type (e.g. Load
Compensation, Current Limit) are associated with the PM and are described in this
Manual.
Some parameters can be both read and written to (edited) by an OEM or a Dealer.
Other parameters can only be read but not edited. Some parameters available to an
OEM are not displayed for a Dealer.
The Load Compensation parameter can be set using the HHP. Veer Compensation
should be set using the HHP to calibrate the DX System to the motors on the
wheelchair. The adjustable range for these two parameters by the HHP can be
limited by the Wizard.
Summary of Contents for DX Power Module PMB
Page 5: ...Contents ...