Dynamic DS120, Installation Manual, Page: 65 / 128

Chapter 4: Programming the Rhino2
65
4.4.1.6 Sleep Beeper
Parameter Possible Values Default HHP Lite Std Adv
Sleep Beeper No / Yes Yes    
This parameter is only used when
Enable Beeper has the value 'Yes'.
Yes - When the controller goes to sleep, the buzzer beeps for one second.
No - When the controller goes to sleep, the buzzer does not beep.
4.4.1.7 Motion Beeper
Parameter Possible Values Default HHP Lite Std Adv
Motion Beeper
Wizard
None
Reverse
Forward/Reverse
HHP
Yes
No
Wizard
Reverse
HHP
No











This parameter is only used when
Enable Beeper has the value 'Yes'.
None - The scooter does not beep when it is moving
Reverse - The scooter beeps only when it is moving in the reverse direction
Forward/Reverse - The scooter beeps when it is moving in any direction
4.4.1.8 Reversing Beeper
Parameter Possible Values Default HHP Lite Std Adv
Reversing Beeper
Yes
No
No
 
Note that the
Reversing Beeper parameter does not exist in the Wizard since the Motion
Beeper parameter can be used to switch on the beeper for reversing.
When using the HHP to program, use both the
Motion Beeper and the Reversing Beeper
parameters, as set out in the table below.
Motion Beeper Reversing Beeper Wizard Equivalent
No Yes Reverse
Yes Yes None
No No None
Yes No Forward/Reverse
4.4.1.9 Beeper Timing
Parameter Possible Values Default HHP Lite Std Adv
Beeper On Time 100 – 1500ms 300ms
  
Beeper Off Time 0 – 1500ms 700ms   
These parameters are only used when
Enable Beeper has the value 'Yes'.