The illustrations may differ in some details from the original. Subject to change without prior notice.
Copyright
©
2016,2017 by Dynamic Projection Institute GmbH. All Rights Reserved. http://www.dynamicprojection.com - MDC_QSG - Version 1.0.8- Page 2
Copyright
©
2016,2017 by Dynamic Projection Institute GmbH. All Rights Reserved. http://www.dynamicprojection.com - MDC_QSG - Version 1.0.8 - Page PB
Quick Setup Guide for MDC-X1 and MDC-X2
Table of contents
1. Connecting the output devices
Page 3
2. Starting the MDC for the first time
Page 6
3. Starting the demonstration project
Page 11
4. Connecting remotely to the MDC
Page 15
5. Network settings and WiFi connections
Page 17
6. Changing the keyboard layout
Page 18
7. Scheduler
Page 19
8. Remote Control of the MDC-X system
Page 21
9. Automatisation programming
Page 23
10. Updating MDC-X and further information
Page 26
BEFORE YOU TURN ON ANY COMPONENT YOU HAVE TO MAKE ALL CONNECTIONS. THE
ILLUSTRATIONS BELOW SHOW YOU HOW TO CONNECT THE MDC TO THE MIRROR HEAD, PROJECTOR,
MONITOR AND KEYBOARD/MOUSE DEPENDING OF WHAT TYPE OF MDC YOU BOUGHT. PLEASE READ THE
INSTRUCTION CAREFULLY! IF YOU ARE UNSURE PLEASE CONTACT US!
Below you see the connection diagrams for the MDC-X1 and MDC-X2 system. Please make sure you have all cables
and adapters ready before you start connecting the systems.
Backside of the MDC-X system
In the case of an MDC-X1 system you do not need the “Network Switch”. The second output is not fully available on a
MDC-X1 system, so DO NOT CONNECT A DEVICE.
•
DO NOT OPEN THE MDC-X CASE .
•
DO NOT COVER THE VENTILATION ON TOP AND OF THE SIDE OF THE MDC-X.
•
DO NOT USE ANY OTHER POWER SUPPLY THAN THE ONE THAT WAS SHIPPED WITH THE
UNIT.
Network Switch
(required for X2 setup)
KMouse (optional)
Projector #1
X1 and X2
Projector #2
only X2
Monitor (optional)
Mirror Head #1
(X1 + X2 Setup)
Mirror Head #2
(X2 Setup only)
