14
Dymax BlueWave® LED Flood System User Guide
System Connections
WARNING!
Make sure the unit is turned off and unplugged before you make any connections
to the back panel. Never attempt to unplug or attach a cable when the unit is turned on.
AVERTISSEMENT!
Assurez-vous que l'unité est hors tension et débranché avant d'effectuer
une connexion sur le panneau électrique (derrière l'unité). Ne jamais débrancher ou attacher un
câble lorsque l'unité est alimentée.
NOTE:
The unit should be positioned so that the back panel of the power supply can easily be
accessed should the power need to be disconnected.
Interconnect Cable
The interconnect cable runs from the back panel of the power supply to the top of the LED flood array.
Figure 5. Connect Interconnect Cable to
Power Supply
Figure 6. Connect Opposite End of
Interconnect Cable to LED Flood Array
Operating the LED Light
Adjusting Intensity
The output intensity can be adjusted from 10% (depending on the LED Flood configuration ordered) to 100%
in 1% increments. To adjust the intensity:
1.
From the main screen, press and hold the button on the front control panel for several seconds until
the Options Menu (Figure 7) appears.
2.
Use the
and the
so that
the “Adjust Intensity” option
is flashing and press the button to enter
the Adjust Intensity Menu (Figure 8).
3.
Use the
,
, , or keys to adjust the intensity setting. Press the Set button to enter
the value and exit to the main page.
