dye NT11, Owner'S Manual

Page: 5 / 22

NOTE: Even with the air supply removed the marker may
have gas inside. Be sure to vent this gas. Make sure there are
no paintballs in the breech and dry fire the marker in a safe
direction.
NT11 BOARD
SETTINGS AND FUNCTIONS
TURNING THE NT11 ON AND OFF
To turn on the NT11, press and hold the power button for
3 seconds (see figure 1) until the LED’s turn blue. The blue
light indicates board boot up. After the boot up sequence,
the LED’s will turn either RED (no ball) or GREEN (ball
ready to fire). To turn the NT11 off, press and hold the power
button until the LED’s turn off.
NOTE: THE NT11 AUTOMATICALLY SWITCHES OFF AFTER
10 MINUTES OF NON-USE.
FIRING THE NT11
As soon as the marker is turned on and the LED’s turn from
blue to either red or green, the NT11 is ready to fire. If there
is no ball and the LED’s are RED, you need to hold the
trigger for 1 second to force the NT11 to fire once. If there is
a paintball inside the breech and the LED is green, just press
the trigger to fire the marker.
LED LIGHT INDICATOR
The NT11 uses two super bright LED’s mounted on the circuit
board inside the grip frame. These two lights are used to
provide information to the user about the NT11. They will
always show the same information and it does not matter
which LED you look at. One is mounted behind the DYE
logo on the left side of the grip panels. The other one can be
seen by looking at the top left side of the grip frame while
holding the NT11 in the position you would while playing a
game.
FIGURE 1
NOTE: The eye is always activated
when you turn the marker on.
W W W . D Y E P A I N T B A L L . C O M W W W . D Y E P A I N T B A L L . C O M
6 7
ULTRALITE AIRPORT - FEEDNECK
CAM LEVER FEED NECK
The Cam Lever Feedneck is adjustable to fit any standard
loader. To adjust the cam locking system, lift the cam lever
away from the feed collar, and rotate the lever clockwise
to tighten or counterclockwise to loosen the grip on
the loader. Once the cam lever is facing in the forward
direction, press the cam lever down against the feed collar
to secure the loader in the feedneck. To loosen the locking
system and remove the loader, lift the cam lever away
from the feed collar. Take care not to over-tighten the cam
locking system. The lever should not be overly difficult to
lower into the locked position.
ON/OFF ULTRALITE AIRPORT
The NT11 comes equipped with an ON/OFF Ultralite Airport
attached to the bottom of the frame. To turn on the gas
supply, rotate the side lever counter clockwise until the
internal stop is reached. To turn off the gas supply, rotate
the side lever clockwise until the other stop is reached. As
you rotate the side lever past the mid point, the residual gas
between the Hyper3™ and the ON/OFF airport will vent. See
page 32 for service information. To remove the UL Airport
from the UL frame see page 26.