dye NT11, Owner'S Manual

Page: 11 / 22

BOOST BOLT
ASSEMBLY AND MAINTENANCE
BOOST BOLT
ASSEMBLY AND MAINTENANCE
ASSEMBLY
• Insert the Bleed Button into the Spacer Rod and screw the Spacer Rod into the Backcap using
a 1/4” Allen wrench and 7/16” wrench to tighten snugly. Take care not to over-tighten the two
pieces together. Excessive force may twist, warp, and ultimately break the Spacer Rod.
• Insert the Spool Spring and Spool into the Plunger. Make sure that the Spool is facing the
correct direction (see page 19).
• Screw the Spacer Rod into the Plunger. It is only necessary to hand tighten the Spacer Rod
and Plunger. Applying lube to the 011 o-ring can reduce sticking.
• Insert the Bolt Soft Tip into the front of the Bolt.
• Insert the Bolt Flow Insert from the back of the bolt, with the larger diameter of the insert
facing rearward.
• Push the bolt onto the Plunger and screw on the Cylinder only hand tight. Replace the 014 Bolt
tip O-ring, and screw the Boost Bolt Kit back into the body using a 1/4” Allen wrench.
BACKCAP/BLEED ASSEMBLY
The Bleed assembly consists of the Spacer Rod, the Backcap, Backcap Cover, and Bleed Button.
The purpose of the bleed assembly is to offer a way to de-gas your NT without having to fire a
shot. It also acts as safety mechanism so that a tool cannot be used to unscrew the bolt kit while
there is gas in the NT.
To completely de-gas the NT, simply deactivate the ON/OFF UL Airport located on the bottom of
the gripframe and then press the Bleed Button until all gas is released.
NOTE: LOW OR ERRATIC VELOCITY MAY BE DUE TO A LOW BATTERY NOT SUPPLYING
AMPLE ELECTRICAL CURRENT TO THE SOLENOID. IN THIS CASE, CHANGE THE BATTERY.
W W W . D Y E P A I N T B A L L . C O M W W W . D Y E P A I N T B A L L . C O M
19 18
Component:
1 Cylinder 5a Spacer Rod
2 Bolt 5b Backcap
3 Plunger 5c Bleed Button
4a Spool Spring 5d Backcap Cover
4b Spool
O-rings:
A.
005
F.
014
B.
010
G.
015
C.
011
H.
017
D.
111
I.
020
E.
012
1 2 3 4a 4b 5a 5b 5c 5d
E F I B I G D C I A C F
Note: A 017 o-ring is housed within the Cyinder(1) and is not visible in this diagram.
B