DVTEL Pro Line 9460A, User Manual

Page: 34 / 58

Pro Line 9460A User’s Manual
4-2
To access the CLI via the Telnet terminal
•
Using Microsoft Telnet, click Start — Run . In the command line, enter telnet <host name>
(where host name is the IP address of the device), and press ENTER.
•
Using the Unix / Linux Telnet, at the prompt enter telnet <host name> (where host name is
the IP address of the device).
The Telnet terminal appears.
Figure 4-2: Telnet terminal
Using the Telnet terminal, you can access and edit all configuration parameters of the edge
device.
Using the CLI
Using the CLI, you can configure the following parameters of the displayed edge device:
•
Setting Serial Port Parameters
•
Setting the Access Management Parameters
•
Setting the System Status Parameters
•
Setting Network Parameters
•
Setting the Ethernet Communication Parameters
•
Setting Advanced Parameters
— Video, Video Status, Serial Port Status, VSIP, VSIP Statistics,
Audio, Test and Debug, Outputs Control, System Time, System Time Stats
Note:
The CLI has a time out that is triggered after three minutes of inactivity. When the time out
occurs, you lose access to the command line and the Telnet terminal closes automatically.