DVTEL Pro Line 9460A, User Manual

Page: 15 / 58

Configuration and Installation
2-7
Surface Mount
You have two options when using the surface ring, it either needs to be mounted before the base
is installed (only required if using the 3 addition mounting locations on the surface ring) or you
insert the dome housing into the surface ring before mounting with the screw locations shown
below.
4. When mounting make sure you install the large rubber gasket between the housing and the
surface ring or if recessed mounting between the housing and mounting surface.
5. Insert the network cable and optional power cable through one of the conduit entry points and
connect them to the dome as described under bench installation.
6. If running conduit to the unit you will need to install a 3” threaded pipe nipple through the
surface ring and thread this into the housing. Use appropriate sealing agent on the connection to
maintain the IP rating of the housing.
7. If applicable, connect the audio and alarm inputs/outputs to the 8 wire cable located in the lower
part of the housing. Refer to the following table to determine which wires correspond to the
inputs outputs relevant to your installation.