3
RMO100A Introduction, Safety Instructions
1 Introduction
This Manual contains helpful instructions on how to use RMO100A in a safe, proper and efficient way.
Following these instructions can help you to avoid dangerous situations, repair costs and other miss
happenings due to incorrect operation. Furthermore it ensures the reliability and life cycle of your
RMO100A.
RMO100A must be used in observance of all existing safety requirements/ regulations from
national/local standards for accident prevention and environmental protection.
Reading the RMO100A Manual alone does not release the user from the duty of complying with all
national and international safety regulations relevant for working with RMO100A.
2 Safety Instructions
Before operating RMO100A, please carefully read the following safety instructions.
It is not recommended that the RMO100A will be used (or even turned on) without the understanding of
this Manual.
RMO100A should only be operated by trained and authorized personnel.
Rules for Use
• RMO100A should only be used when in a technically fit condition. Its use should be in accordance
with the safety regulations for the actual working site and application. Always be aware of the dangers
of high voltages and currents associated with this equipment and its environment. Pay attention to the
information provided in the operations Manual.
• RMO100A is intended exclusively for the application areas specified in ”Designated Use”. The
manufacturer and distributors are not liable for damage resulting from unintended usage. The user
alone assumes all responsibility and risk.
• The instructions provided in this Manual are considered part of the rules governing proper usage.
• Do not open RMO100A. All service and maintenance work must be performed by qualified personnel.
Orderly Practices and Procedures
• The Manual should always be available on the site where the RMO100A is used.
• Before using RMO100A, all personnel (even personnel who only occasionally, or less frequent, work
with RMO100A) assigned to RMO100A should read the operations Manual.
• Do not undertake any modifications, extensions, or adaptations to the RMO100A.
• Use RMO100A in conjunction with original accessories only.
• Use both RMO100A and its original accessories for its designated use only.
Cleaning
To clean RMO100A, use a cloth dampened with isopropanol alcohol or water.
Safe Operation Procedures
• Hazardous voltages of up to 400 V can occur inside RMO100A. Therefore is not permitted to open
RMO100A.
• Do not insert objects (e.g., screwdrivers, etc.) into the ventilation slots.
• Before putting RMO100A into operation, check the test set for visible damages.
• Do not operate RMO100A under wet or moist conditions (condensation).
• Do not operate RMO100A when explosive gas or vapors are present.
• The serial interface of RMO100A should only have external devices connected that meet the
requirements for SELV equipment according to EN 60950 or IEC 60950.
• When setting up RMO100A, make sure that the air slots of the test set remain unobstructed.
• If RMO100A is opened by the customer, all guarantees are invalidated.
• If RMO100A seems to be functioning improperly, please contact the IBEKO Power AB (refer to
section ”Manufacturer Contact Information”) after first checking the section Error Messages.
