Dürkopp Adler D669, Operating Instructions Manual

Page: 81 / 226

Programming
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020 79
5.6.3.2 Setting the
Correction speed effect
parameters
Some parameters are affected by high speeds because of
the resulting physical effects. To counteract these effects and
to achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Overview of settings modes
The correction of the effects of high speeds can be identified in
various modes and responded to depending on the setting.
This general explanation can be applied to the following specific
parameters.
Setting mode Description
linear
In the linear setting, the size of the parameter
increases or decreases steadily as the speed
increases. The increase/decrease of the parameter
depends on the limits set for the minimum and
maximum speed.
2.OnOff
If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it switches to the base value for the
parameter.
2.On
If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it does NOT switch to the base value
for the parameter. Only after finishing the seam by
cutting the thread is the base value for the parameter
set again.