Dürkopp Adler D669, Operating Instructions Manual

Page: 180 / 226

Troubleshooting
178 Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
1004 Error Incorrect sewing motor
direction of rotation • Replace encoder
• Check motor plug assignment and
change it if necessary
• Check wiring in machine distributor and
change it, if necessary
• Test motor phases and check for correct
value
1005 Error Motor blocked • Check for stiff movement
• Replace encoder
• Replace sewing motor
1006 Error Maximum speed exceeded • Replace encoder
• Perform reset
• Check class (t 51 04)
1007 Error Error in the reference run • Replace encoder
• Check for stiff movement
1008 Error Sewing motor encoder error • Replace encoder
1010 Error External synchronizer plug
(Sub-D, 9-pin) not
connected • Connect cable of external synchronizer to
control, make sure that interface (Sync) is
correct
• Only recommended for machines with
transmission!
1011 Error Encoder Z pulse missing • Switch off the control, use handwheel to
turn, and switch on the control again
• If error is not corrected, check encoder
1012 Error Synchronizer fault • Replace synchronizer
1054 Error Internal short circuit • Replace control
1055 Error Sewing motor overload • Check for stiff movement
• Replace encoder
• Replace sewing motor
1060 Error Sewing motor overload /
overvoltage /overcurrent • Check selection of class
• Replace control
• Replace motor
• Replace encoder
1061 Error Sewing motor overload /
overvoltage /overcurrent • Check selection of class
• Replace control
• Replace motor
• Replace encoder
Code Type Possible cause Remedial action