Dürkopp Adler D669, Operating Instructions Manual

Page: 197 / 226

Troubleshooting
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020 195
6364 Information No valid data on internal
EEprom and no external
EEprom connected (the
internal data structures are
not compatible with the
external data storage
device)
• Check machine ID connection
• Switch off the control, wait until the LEDs
have gone out, and then switch on the
control again
• Software update
6365 Information Internal EEprom defective • Replace control
6366 Information Internal EEprom defective
and external data not valid
(emergency operating
features only)
• Replace control
6367 Information Internal EEprom defective
and external data not valid
(emergency operating
features only)
• Replace control
7270 Information External CAN • Check connection cables
• Perform a software update
• Replace CAN slaves
9310 Error Tape feeder not connected • Check connection cables
• Perform a software update
• Replace the control of the tape feeder
9320 Error Tape feeder in lowered
position • No remedial action entered in translation
table
9330 Information Material thickness sensor
not connected
• Check connection cables
• Perform a software update
• Replace material thickness sensor
9340 Error Remaining thread monitor
not connected • Check connection cables
• Perform a software update
• Replace remaining thread monitor
9910 Warning Sewing stop • Check tilt sensor on machine
• Check 24V
• Replace control
9911 Warning Power down • The control is switched off
Code Type Possible cause Remedial action