DURKOPP ADLER 512-211-01, Service Instructions Manual

Page: 57 / 82

Settings via software
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016 55
5. Press the P5 button.

The process for downloading to the controller starts. This will take
approx. 4 minutes.
6. Press the Reset button.
7. Remove the USB stick.

The software transfer is complete.
11.24.3Setting parameter U085 (class 532)
After installing new software, parameter U085 must be set for the button
sewing machine.
Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
is off.
1. Press and hold the Memory button for 6 seconds.

The LED in the button illuminates.
2. Select parameter number U085 by using the +/- Program buttons.
3. Press the Ready button.
4. Enter the function value 1 by using the +/- Function buttons.
5. Press the Selection button.
11.24.4Checking the software version
1. Press and hold the Memory button for 6 seconds.

The controller beeps 2x; the LED in the button illuminates.
2. Press the +/- Program buttons and select parameter U097 .
3. Press the Ready button.

The current software versions are displayed:
• M X.XX = Main program
• P X.XX = Control panel
• T X.XX = Servo motors
• A X.XX = Sewing patterns
4. Press the +/- Function buttons and check the respective software ver-
sion.
5. Press the Ready button.
6. Press the Memory button.

The LED in the button switches off.