24
Chapter 4 Configuring the System
4-3. Setting Network Cameras
●
To automatically discover network cameras
Discover network cameras on the network automatically and register them to the system.
This procedure is for setting network cameras connected after performing “Easy Setup” upon initial
startup of the monitor.
Attention
•
Only the network cameras installed in the same subnet as the monitor are detected. If a network camera is
installed in a different subnet, the camera must be registered manually (see “To manually register network
cameras” (page 24)).
• For information on “Easy Setup”, refer to the Setup Manual.
Procedure
1.
Select “Auto Discovery”.
Displays
registered
cameras.
1
2
3
2. Select “Start” at “Camera Discovery”.
Automatic discovery is started and a “Searching” message is displayed.
When the search is completed, the discovered network cameras are added to the list.
3.
Select “Apply”.
The setting complete screen is displayed. Select “OK”.
Attention
• When network cameras are not detected by automatic discovery, see “Chapter 5 Troubleshooting” (page
43).
Note
•
The settings of the newly detected network camera (camera name, IP address and HTTP port) can be
changed. Select the network camera to make setting changes at “Camera Name” and then select “Settings”.
Configure the items on the displayed setting screen.
• When a network camera is registered automatically, the username, password and stream name for accessing
the camera are set to the following values automatically. (These settings can be changed on the Manual
Setting screen (see “To manually register network cameras” (page 24).)
-
Username: “admin”
-
Password: “12345”
-
Stream: “2”
●
To manually register network cameras
Register network cameras manually for cases described below.
• When a network camera is installed in a subnet differing from the subnet of the monitor.
• When settings such as network settings of a registered network camera have been changed.
Summary of Contents for FDF2304W-IP
Page 2: ......
