6
PF Conveyors | Installation, Operation & Maintenance Manual
u
Install Guards
/
Štitnici pri ugradnji
1
x4
x4
1
EN
1
Ensure that all twist nuts are
in the vertical position.
2
Match the clear plastic guard
numbers with the correspond-
ing numbers on the conveyor
(4 clear plastic guards for each
conveyor).
3
Install all 4 clear plastic
guards over the twist nuts
and onto the conveyor.
4
Twist all of the nuts to the
horizontal, locked position.
CR Uvjerite se da su sve zavojne matice
u okomitom položaju
Uskladite brojeve štitnika s
odgovarajućim brojevima
na transportnoj traci (4 štitnika za
svaki transporter)
Ugradite sva 4 štitnika preko zavrtanih
matica i na transporter
Zavrnite sve matice u vodoravni,
zaključani položaj
Repeat this procedure for the second conveyor.
Ponovite ovaj postupak za drugu transportnu traku.
u
Connecting Conveyors to Controllers
/
Spajanje transportnih traka na upravljače
START
STOP
RESET
x2
EN
1
Connect the ECU conveyor to
the control panel using the
ECU wire connector on the control.
2
Connect the PREP conveyor
to the control panel using the
PREP wire connector on the control.
3
Remove the plastic cover
on control, turn the circuit
breaker on, and remove the wire
ties from the face plates. Then re-
place the plastic cover. turn circuit
breaker on, and remove wire ties
from face plates. Then replace
plastic cover
4
Turn the control switch on
both the PREP and the ECU
tables to the <
RESET>
(
)posi-
tion and release.
CR Spojite ECU transportnu traku na
upravljačku ploču pomoću konektora
žice ECU na upravljaču
Spojite PREP transportnu traku na
upravljačku ploču pomoću konektora
PREP žice na upravljaču
Skinite plastični poklopac na
upravljaču, uključite prekidač i uk-
lonite žičane vezice s prednjih ploča.
Zatim zamijenite plastični poklopac
Okrenite upravljački prekidač na
PREP i ECU stolnim kontrolerima u
položaj za resetiranje i otpustite ( )
Conveyors are now ready for commissioning.
Transportne trake su sada spremne za puštanje u rad.
