Duracell inverter 1000, Owner'S Manual

Page: 54 / 65

Battery Tips
975-0347-01-01 B–7
Battery Tips
Explosive/
Corrosive
Gases Lead-acid batteries may emit hydrogen gases, oxygen, and sulfuric acid
fumes when recharging. To reduce the risk of explosion:
• Vent the battery compartment to prevent the accumulation of gases.
• Do not install electronic or electrical equipment in the battery
compartment.
• Do not smoke or use an open flame when working around batteries.
Temperature
Sensitivity The capacity of lead-acid batteries is temperature sensitive. Battery
capacity is rated at 77 ºF (25 ºC). At 0 ºF (–20 ºC), the Ah capacity is
about half the rated capacity. You should consider temperature when
designing your system.
• Low Temperatures If extremely low temperatures are expected
where the inverter is going to be located, you should consider a
heated equipment room. If the system is located in an unheated space,
an insulated battery enclosure is recommended.
• High Temperatures The batteries should also be protected from high
temperatures. These can be caused by high ambient temperatures,
solar heating of the battery enclosure, or heat released by a nearby
engine or generator. High battery temperatures shorten battery life
and therefore you should ventilate the enclosure and use shade and
insulation as appropriate.
Discharged
Batteries Do not leave batteries in a discharged state for more than a day or two.
They will undergo a chemical process (sulfation) that can permanently
damage the battery. As well, batteries self-discharge over a period of three
to six months, and they should be recharged periodically even if they are
not being used.
Electrolyte
Level If your batteries are not the “maintenance-free” type, check the electrolyte
level at least once a month. Excessive fluid loss is a sign of overcharging.
Replenish the electrolyte using only distilled water.
Battery
Connections Connections to battery posts must be made with permanent connectors
that provide a reliable, low-resistance connection. Do not use alligator
clips. Clean the connections regularly and prevent corrosion by using a
protective spray coating or Vaseline.
WARNING
Review “Precautions When Working With Batteries” on page vii before you
work with the batteries in your system.
Duracell1000.book Page 7 Friday, September 7, 2007 1:47 PM