Duplo DC-645, Instruction Manual, Page: 64 / 106

63
1
3
Prog
ra
ming JOB f
or DC-645 on Control P
anel
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Use the <+> key and <–> key to switch the
creasing depth between and set MAX, Mid or
MIN.
The crease will be deep when MAX is set and
will be shallow when MIN is set.
Press the <SET> key when input is completed.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Press the <SET> key to retain the settings or
<C> key to cancel the settings.
[MEMORY !!] is displayed when the JOB is
saved on the DC-645 memory circuit.
The memorization process will take approximately 1.5
seconds.
CREASE DEPTH
MAX
∗
MID MIN
OVER WRITE ?
OK( ) NO(C)
MEMORY !!
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Use the <+> key and <–> key to switch between
and turn ON/OFF.
Press the <SET> key when input is completed.
AUTO CUT
∗
ON
OFF
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Use the <+> key and <–> key to switch between
and set High or Low processing speed.
Set to LOW for better processing precision.
Press the <SET> key when input is completed.
SPEED
∗
HIGH
LOW
How to Program Job on Control Panel
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Use the <+> key and <–> key to switch between
and turn ON/OFF the Slit Guide function.
When this function is ON, the unused slitter
acts as a paper transport guide.
Press the <SET> key when the setting is set.
Tip
• Turn ON only when the document weight is light.
SLIT GUIDE ON
∗
OFF