Duplo DC-645, Instruction Manual, Page: 58 / 106

57
1
3
Prog
ra
ming JOB f
or DC-645 on Control P
anel
How to Program Job on Control Panel
Optional module ............................ Select an optional module for the job when necessary.
JOB number ................................... Select a JOB no. in which the JOB currently being
programmed is saved.
JOB name ....................................... Put a name to the JOB with number keys for easy
reference.
Paper length ................................... length of document
Paper width .................................... width of document
REG MARK position .................... When using REG. mark reading:
The distance between lead edge and leadmark, and the
distance between right edge and side mark.
Slit positions ................................... Distances between right edge and each slit position.
DC-645 can slit up to 6 positions on 1 document.
Cut positions .................................. Distances between lead edge and each cut positions.
DC-645 can cut up to 15 positions on 1 document.
Crease position ............................... Distances between lead edge and each crease positions.
DC-645 can crease up to 10 creases on 1 document.
Option positions ............................. Distances between right edge and each option positions.
AIR KNIFE .................................... Compressed air is blown out to loosen the document.
This is to prevent double-feed.
FAN REGISTER ........................... Document skewing in feeding area is corrected. When
processing light weight document, turn this function
OFF as it may cause a paper jam in feed area.
SLIT GUIDE .................................. When any slitters are not used, these slitters act as
paper guide to stabilize the paper conveyance.
Recommended for light weight document.
AUTO CUT .................................... Lead margin, trail margin, and any gutter cuts (shorter
than 85mm) are finely cut and dropped into the waste
box. When documents do not have lead margins or trail
margin, this must be turned off.
CREASE DEPTH .......................... This sets the depth of the crease when creasing a
document. Set to MAX for heavy paper and MIN for
light paper.
SPEED ............................................ This is used to select HIGH/LOW processing speed.