Duplo DC-645, Instruction Manual, Page: 60 / 106

59
1
3
Prog
ra
ming JOB f
or DC-645 on Control P
anel
PREPRINTED
SAMPLE
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the total length (in mm) of the document.
Press the <SET> key when input is completed.
Tip
• When programming a JOB (INPUT mode), press
the
<
JOG> key to move to NEXT or Previous
display.
<JOG> key: Go to the next display
<JOG> key: Go to the previous display
Tip
• When programming a JOB (INPUT mode), press
the <STOP> key to quit the JOB program and
return to the regular LCD display.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the paper width (in mm) of the document.
Press the <SET> key when input is completed.
How to Program Job on Control Panel
TOTAL LENGTH ?
(210–650)460.0mm
PAPER WIDTH ?
(210–370)297.0mm
SIDE MARK 10.0mm
(0,3–15)
10mm
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Measure the distance (in mm) between the
Right edge of the paper and the vertical portion
of the Side mark. Input the distance of Side
mark by <Number> key.
The value must be between 3 and 15 mm when
REG. Mark is not used enter 0.0 mm.
Example:
1. Press the < 3 > key and <JOG> key.
2. Press the < 8 > key 2 times and <JOG> key.
3. Press the < 7 > key and <JOG> key.
4. Press the < 5 > key 3 times and <JOG> key.
5. Press the < 6 > key 3 times and <JOG> key.
6. Press the <SET> key.
52:DUPLO
1 2 3 4 5
Continue Page
• • •