Duplo DC-645, Instruction Manual, Page: 61 / 106

60
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the value from step 9 using the
<Number> key. When REG. Mark is not used,
enter 0.
Press the <SET> key when input is completed.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Measure the distance (in mm) between the
leading edge of the paper and the horizontal
portion of the REG. Mark. The value must be
between 3 and 15 mim.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the distance from the right edge of the
document to the position for SLIT1. This value
must be between 0 and 40 mm.
Press the <SET> key when input is completed.
Tip
• When selecting “Business card module” for
optional module, slit positions do not need entry.
Go to step 18.
Tip
• The document will be ejected if the slit position
exceeds the 40 mm upper cutting limit by the
margin slitter due to “REG. mark print position
drift” or “Side mark entry error”.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the distance from the right edge of the
document to the position for the SLIT 2.
This value must be between 257 and 297 mm.
Press
the <SET>
key when input is completed.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Enter the distance from the right edge of the
document to the position for the SLIT 3.
This value must be between 58 and 212 mm.
Press the <SET> key when input is completed.
How to Program Job on Control Panel
10mm
LEAD MARK 10.0mm
(0,3–15)
SLIT 1 10.0mm
(0– 40.0)
SLIT 2 260.0mm
(0,257.0–297.0)
SLIT 3 110.0mm
(0,58.0–212.0)