Twin Twist Soft Serve Freezer Model 957RMT
30
184957
9.3
Dispensing Product
1. To dispense product, grasp the spigot
handle, hold the container which is to
be filled with product below the spigot,
and slowly open the spigot until
product is dispensed at a comfortable
rate.
2. When the proper portion has been
dispensed, close the spigot.
3. The freezer will continue to run a
short time (approximately 12 seconds)
following the dispensing of the
product. If a large portion has just
been dispensed, a longer period of
time may be required for the freezer
to shut off.
4. If the freezer has not been used for
more than two and a half minutes,
and the product requires a firm base,
then dispense a small amount of mix
in the spigot into a separate container.
NOTE:
For shakes, large sundaes, floats
and other similar products, this practice
of drawing off a small amount into a
separate container is not necessary and
should be discouraged.
5. Observe the level of mix throughout
the day to avoid running out of
product in the mix containers or bags.
6. Periodically check the temperature
and overrun of product and make sure
it is within the specified limits.
IMPORTANT:
If proper mix level is not maintained,
a freeze-up may occur and cause
damage to the freezer.
Summary of Contents for DQ 957RMT
