Duke DQ 957RMT, Operator’S Manual With Illustrated Parts List

Page: 32 / 83

Twin Twist Soft Serve Freezer Model 957RMT
22 184957
d. the air bleed plug o-ring grooves
e. the beater shaft and the scraper
blade pin holes, as shown in figure
6-6.
Important:
Do not leave parts in sanitizer for
longer than 15 minutes.
3. After all parts are washed, rinse and
place them in the sanitizing solution.
For proper sanitizing, the parts must
remain fully immersed in the sanitizer
for 5 minutes. Allow the parts to air-
dry after sanitizing.
4. The following must be thoroughly
brushed first with a warm dish
deteregent solution, then rinsed with
clear water followed by the sanitizing
solution.
a. mix feed tubes from the
refrigerated cabinet to the cylinders
as shown in figure 6-7
b. the inside of the cylinders
including the back wall as shown in
figure 6-8
c. the inside of the drain tube as
shown in figure 6-9
5. Remove the drip tray and insert. Wash
in a warm dish detergent solution
rinse with clear water and place in
sanitizing solution for 5 minutes.
6. Wash the outside of the freezer and
inside of the cabinet with a warm dish
detergent solution. Rinse with clear
water.
Rep lace worn brushes.
Use only original or authorized re-
placement parts.
See Accessories Parts List in Part II of
this manual to o rder new brushes.
7.3 Cleaning Instructions
(continued)
Figure 7-8 Scraper Blade pin holes
Figure 7-10 Clean Drain Tube
Figure 7-9 Clean Cylinders