Duke DQ 957RMT, Operator’S Manual With Illustrated Parts List

Page: 41 / 83

Twin Twist Soft Serve Freezer Model 957RMT
184957 31
10.1 Draining Product
At the end of each day of operation, the freezer must be rinsed, sanitized, and
disassembled. The parts also must be washed, rinsed, sanitized, and prepared for
reassembly.
To remove frozen product from the
cylinders:
1. Place the selector switches in the
“CLEAN” position and the MTS pump
switches in the “ON” position.
2. Let the beaters run for 5 minutes. This
will allow the product in the cylinders
to soften.
3. In the cabinet below (see figure 9-1).
Disconnect the mix probe cords from
the back of the cabinet.
4. Remove each mix tanks while pulling
the stainless steel pickup tube from
the mix tank. Place the pickup tubes
in a clean sanitized container.
5. Mix must be handled according to
local health codes.
6. Place a clean sanitized container
under the dispensing head.
7. Very slowly open the side spigots and
dispense the semi-frozen product until
it quits dispensing. To eliminate waste,
dispense as much as possible for use
in pints, quarts, and/or novelties.
8. Close spigots. Place the MTS pump
switches and the cabinet switch to the
“OFF” position.
9. Place the mix pickup tubes into a
container and fill with cold water. Turn
the MTS pump switches to “ON” and
allow the MTS to fill and pressurize
the cylinders.
— continued
Figure 11-1
10 Closing Procedures