5.
ATEL ONLY: Pressing the MUTE function (F6 factory default) will alternately mute
and unmute both the transmitter and receiver in handset operation, or mute and
unmute the panel microphone in speaker/microphone operation.
6.
ATEL ONLY: If push-to-talk speaker/microphone operation is desired, press and
release TALK to manually control the audio direction. The MUTE function is not
available in this mode of operation.
7.
ATEL ONLY: If you are using the speaker/microphone, you can adjust the speaker
listen volume by pressing the VOL up/down key.
8.
ATEL: Hang up the handset or press SPKR PHONE to end the call. Failure to
replace the handset in the cradle will cause the ATEL to switch to an on-hook mode
of operation after a preset duration. If the ATEL converts to an on-hook mode, it still
rings as if the handset is in the cradle, therefore no calls are missed.
STEL, DTMF telephone, or CTEL: Hang up the handset to end the call.
Note:
The handset must be on-hook for a minimum of two seconds to end the call.
Outside Line Access (Fusion feature set)
An outside line is a telephone line that comes from the central office directly into a build-
ing. These lines can be accessed either directly from the STARCall system through a
COC (Central Office Card) within the system or via a PBX system connected to
STARCall.
Inbound calls connected through the COC card with the optional TCM (Trunk Caller-ID
Module) will display Caller ID information on telephones so equipped.
Outside line access for every extension is controlled by the class of service assigned.
Contact your System Administrator for details concerning the availability of outside line
access based on class of service assignments in your System.
Calling an Outside Line Connected Directly to STARCall
1.
ATEL: Lift the handset for a private conversation or press SPKR PHONE for
speaker/microphone conversation.
STEL, DTMF telephone, or CTEL: Lift the handset.
2.
Dial the outside line prefix number (usually 9 or 80 to 89) to access an outside line.
To select a specific outside line, use the line pickup code (79XX) to select the desired
line (for example, 7902 will access line 2 for dialing if it is currently idle). See
Using
Telephone Call Pickup
on page 38 or more information.
ATELs display “CO” and a second dial tone is heard when the System is ready for
outbound dialing.
34
SCR+ Telephone Operation Manual
Calling a Telephone
Summary of Contents for SCR+
