Ducati MONSTER S4, Owner'S Manual

Page: 89 / 273

25
E
Shock absorber adjusters (fig. 16)
The shock absorber has outer adjusters that enable you
to adjust your motorcycle to the load.
The adjuster (1) located on the right side, on the
connection holding the shock absorber to the swingarm,
controls rebound damping.
The adjuster (2) on the shock absorber expansion
reservoir controls compression damping.
Turn the adjusters (1 and 2) clockwise to increase
damping, anticlockwise to reduce it.
STANDARD setting:
turn the adjuster (1) all the way in then slacken it 19
clicks. Slacken the adjuster (2) 2 clicks .
Two ring nuts (3), located on the top section of the shock
absorber is used to adjust the outer spring preload.
To change spring preload, slacken the upper ring nut.
Then
tighten or slacken the lower ring nut to increase
or decrease spring preload as required.
Warning
Use a specific pin wrench only to turn the preload
adjusting nut. Be careful when turning the nut with the
wrench, as the pin may slip out of the ring nut recess and
you may hurt your hand hitting motorcycle parts.
The shock absorber is filled with gas under pressure and
may cause severe damage if taken apart by unskilled
persons.
3
1
2
S H
fig. 16
ProCarManuals.com