Ducati Monster 696 2009, Manual

Page: 651 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
P 4
61 Monster 696/696+ - M.Y. 2009 - edition 00
Electrical system
High beam (HI)
Disconnect the wiring connector (3) from the headlight bulb (4).
Release the retaining clip (5).
The bulb (4) is of the bayonet-type: press and twist anti-clockwise to remove.
Fit the new bulb (4), insert the tabs on the bulb base into the corresponding slots to ensure the bulb is correctly positioned,
push the bulb in and turn clockwise until it clicks into place.
Refit the connector (3) to the bulb (4), and the cover (2) to the headlight, tightening the screws (1) to the specified torque
(Sect. C 3, Frame torque settings).
Low beam (LO)
To change the Lo beam headlight bulb (6) see the procedure described above for the Hi beam headlight bulb.
Replace the bulb with a new bulb of the same type (Sect. C 1.1, Lights/instrument panel).
Notes
Do not touch the transparent part of the bulb with your fingers, this will darken it and cause a loss of brightness.
3
4
5
4
6