Ducati 749R, Owner'S Manual

Page: 115 / 382

E
22
Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to
ON
and fully open throttle. Keep it open.
The
EOBD
warning light turns off after 8 seconds.
2) Release the throttle as soon as the
EOBD
warning light
turns off.
3) The
EOBD
pilot light will flash. Count a number of
flashes corresponding to the first figure of the code, open
full throttle and keep the position for 2 seconds, then
release. In this way the input of one figure is
acknowledged,
EOBD
pilot light comes on and stays on for
4 seconds. Carry out the same procedure for the following
figures of the code. Failure to do so will cause the
EOBD
pilot light to flash 20 times, then it will stay on. This means
that the procedure has been aborted. It will be necessary
to turn the key to
OFF
and restart from point (1).
4) Repeat operations described in point (3) up to the last
figure of the code.
5) When you release the throttle, if the code was inserted
in the correct way, you can have two situations, A or B:
A) the
EOBD
light starts flashing to indicate that engine is
enabled. The light goes off after 4 seconds, or if the
engine runs faster than 1000 rpm.
B) the
CODE
light flashes until engine rpm stays below
1000, or until the vehicle is restarted.
6) Should the code NOT be entered correctly both the
EOBD
and
CODE
lights stay on and it is possible to repeat
the procedure starting again from point 2 for as many
times as necessary.
Note
Should the throttle twistgrip be released before
the set time, the warning light turns on again.
It is then necessary to bring the key to
OFF
and restart
the procedure from point (1).