S e c t i o n 3 – S y s t e m P r o g r a m m i n g
31
Incoming Call Control
Dial
at auto answer.
This prevents any extensions ringing until an access code is dialled. This is useful in situations where
users are receiving unwanted calls and wish to limit access to a known group. When incoming call
control is active on a line the normal 5.5-second timeout to become a general call does not apply.
Incoming call control is accessed by dialling 5 at the answer tone, or after the end of the voice
message. Figure 3-6 defines how incoming call control operates.
Figure 3-6 Incoming Call Control Operation Flowchart
Programming Codes
Step 1
: (Optional – fax/voice card must be installed) Record your answering messages, speak at
tone then hang up quietly.
Record answer message 1 at extension 13
Record answer message 2 at extension 13
Step 2
: Enable the auto-answer modes
Switch off incoming call control for all exchange lines
General Settings
Auto answer settings
Disable call control
PIN
PIN
Yes
No
Network disconnect
tone
Ringback
tone
Yes
No
Incoming call
Auto-answered ?
Auto-answer not enabled
Dial 5 for Incoming call
control
Access code
required?
Enter call control
access code
What can be
heard?
Wrong password entered,
call disconnected
Call accepted,
normal incoming call