*
*
Network Address System
Network Public Address System
Network Public Address System
11
2.3 Monitor Module
Amplifier Monitor Device
Setup
LED
Phone utput
MAX
MIN
MIC IN VOL
Setup
MAX
MIN
LINE OUT
VOL LINE IN
OUT+OUT-
MAX
MIN
AMP VOL Net
LED
1. Network indicating LED
When this system is offline, the LED is in green color, and it turns red when network connection to the controller
is re-established.
2. Input level adjustment
To adjust the knob according to the rate of the input audio signal level
3. Audio indicator
The brightness of such indicator is determined by input power signal level of the channel.
4. Amplifier interface
Connect the passive speaker and the other equipment (low impedance 4 ohm/10W or 8ohm/5W)
5. Audio signal line input interface
To connect with other audio source equipment, such as CD, tuner, mp3 and so on.
6. Audio signal line output interface
To output audio line signal, connect with the amplifiers, mixing consoles and so on
7. DIP switch
When the parameters of this module cannot be found, such as IP is not clear, pull down one of the four dial keys,
the indicator will be on, and the local parameters will recover the following specific parameters:
IP
：
192.168.18.2
GATE
：
192.168.18.1
Mask Code
：
255.255.255.0
Main server IP
：
192.168.18.250
Standby server IP
：
192.168.18.251
8. Microphone input interface
The interface connect to other equipment. The input signal is mixed the same input channel with emergency MIC
input (EMC MIC) on front panel. When the emergency MIC Channel is opened (local paging), the interface can
also be selected and output together with the signal of emergency MIC channel. When emergency MIC Channel
was closed (cancel local paging), the signal of the interface will not be output.
9. Headphone/earphone interface
Connect with headphone/earphone
10. DIP indicator
1
2
3
4
5
6
7
8
9
10
