Description Of Controls
Page 59 of 100
057-230 ISSUE: 1
4.5.9
ENGINE DTC (ECU ALARMS)
NOTE: For details on these code meanings, refer to the ECU instructions provided by the
engine manufacturer, or contact the engine manufacturer for further assistance.
NOTE: For further details on connection to electronic engines, refer to DSE Publication:
057-004 Electronic Engines And DSE Wiring
If the DSE module is connected to an ECU, This page contains active
Diagnostic Trouble Codes
(DTC)
only if the engine ECU generating a fault code. These are alarm conditions are detected by the
engine ECU and displayed by the DSE controller.
4.5.9.1
VIEWING ACTIVE ENGINE DTC
To view the engine DTC(s), press both
(up) and
(down) buttons simultaneously, the navigation
menu is then displayed. Once entered, cycle to the DTC (
) section and enter.
To view the active DTC(s) alarms, repeatedly press the
(up) or
(down) buttons until the LCD
screen displays the alarm.
Continuing to press the
(up) or
(down) buttons cycles through the alarms.
To exit the active DTC(s) alarm section, press the
(up) and
(down) buttons simultaneously to
enter the navigation menu. Once entered, cycle to the desired intrunmentation section.
Check engine
1
1
Low - moderate
458852, 18, 126
SPN
458862
1
1
FMI
0
A list of CAN fault icons can be viewed overleaf.
Icon to indicate that
the event log is
currently display
Number of
DTC displayed
out of number
of active DTCs
Icon to indicate
the type of DTC
fault that is
active
Description and
fault code of active
DTC alarm
SPN and FMI fault
code of active
DTC alarm
Current operating
state of the module
