Quickstart
15
2.7
Decoder Configuration
Connect your display to the transmitter via the HDMI or HD-SDI output. Then
open the
Targa Decoder
tab and go to the
Video/Audio
sub tab.
2.7.1
Video Settings
The receiver can decode HD video streams with a resolution of 1280x720
(HD) or 1920x1080 (Full-HD) pixels, SD streams can have resolution of either
448x256, 672x384 or 1024x576 pixels. Set the “Video Mode” to the
resolution of the incoming video stream.
The receiver will scale the incoming video to the selected “Display Timing”.
Please select a timing that matches the framerate of the incoming video
stream.
The video port must match the port of the transmitter.
2.7.2
Audio Settings
You can enable audio playback, which will output the received audio stream
on all three sinks (HDMI, SDI, analog output). Make sure the audio port
matches the transmitter settings.
If you want to transmit an audio return channel from the receiver to the
transmitter, enable the “Audio Return Channel” feature. Only the analog
audio input can be used as source. If the analog audio source is a
microphone, enable the microphone bias by changing the “Micro Mode” (this
will power the microphone with 2 or 2.5V). If you attach an active audio
source (like a DVD player or a smartphone), leave the bias disabled. You can
then adjust the “Capture Volume”, please note that high capture volume
values will lead to high static noise in the recorded signal.
To be able to transmit audio data to a Targa Transmitter which is connected
via LTE you will need to use the VPN feature, because the Receiver cannot
directly reach the IP address of the Transmitter. For further details see
chapter 3.3.2 and 3.5.2.
