25
INPUT - Page 1
INPUT - Page 2
The dotted line shows the -2dB
ceiling.
Rotate the control knob to adjust
the speed of the sweep signal.
Select the rate then rotate the
control knob to adjust the speed of
the sweep signal.
Push the control knob to select either
the Left, Right or Both channels for
adjustment.
Adjust either the Left or Right channel
to correct for any stereo image
unbalance.
Signals levels are displayed
over a period of 1-10 Sec.
A Gain Reduction bar display will
appear if the Gain Management has
responded to peaks.
This will occur to peaks that exceeD
-2dBfs.
The Bar graph shows the level of
digital gain that has been applied to
the input signal.
When Pv is
selected
(using the
Chain/Param
button).
Use the Left/
Right button
to select....
...Left signal phase.
...Left / right swap.
...Right signal phase.
Shows the Input signal with the
revised sweep rate.
...Sweep rate of signal
level graphics.
