REPLACE FUSE AS
- RISK OF FIRE -
MARKED AFTER
DISCONNECTING UNIT
- RISQUE D'INCENDIE -
REMPLACEZ FUSIBLE DU
TYPE INDIQUE APRES
DEBRANCHER DU SECTEUR.
CAUTION:
ATTENTION:
A N T E N N A 2
R E C E I V E O N L Y
V H F / U H F
I N T E R F A C E
R S - 2 3 2 C
F A X /
I N P U T
E X T E R N A L
T N C
D C I N P U T
1 3 . 6 V D C 6 A
+
5 0 / 6 0 H z
7 5 W A T T S
115 OR 230 VAC
SET INTERNALLY
FACTORY SET : 115 V
L I N E
F U S E
1 1 5 V
2 3 0 V
3 A , 2 5 0 V
S L O - B L O
T 1 . 6 A , 2 5 0 V
+ 13.6VDC
@
100 mA
F R O M A C L I N E .
+
G N D
S W I T C H E D
+ 13.6 V
5 0
@
FUSE
A N T E N N A 1
R E C E I V E : V H F / U H F
5 0
T R A N S M I T : 1 4 4 - 1 4 8 M H z
2 5 W A T T S
M A D E I N U . S . A .
BY
R
8
E X T S P K R
D E M O D
2 Introduction - Safety / Voltage Selection
WARNING
NOTE: THE FOLLOWING PROCEDURE REQUIRES REMOVAL OF AN
EQUIPMENT COVER THAT EXPOSES POTENTIALLY LETHAL VOLTAGES IF
THE EQUIPMENT IS POWERED FROM AN AC POWER SOURCE. REFER
SERVICING TO A QUALIFIED TECHNICIAN ONLY.
NOTE: A magnetized screwdriver facilitates the removal
and installation of screws in the procedure that follows:
A) DISCONNECT THE TRANSCEIVER FROM ITS SOURCE OF
AC POWER.
B)
Remove the top cover from the transceiver by
removing (6) Black screws, #6-32 x 1/4" PAN PHL. Retain
the cover and screws for later reassembly.
C)
Locate the power supply cover. Remove the cover
by removing (2) Screws, #4-40 x 1/4" PAN PHL Zinc from
the left-hand side of the unit and by removing (2) Nuts,
Hex #M3 x 6mm from the right-hand side of the compart-
ment cover. Remove the cover by carefully releasing it
from the exposed studs at the right-hand side of the
cover. Retain the cover, screws, and nuts for later
reassembly.
Power Supply
Cover
(2) 1/4" screws
(2) hex nuts
(metric)
Downloaded by
Amateur Radio Directory