46 Quick Reference Guide, continued
MEMORY FUNCTIONS
Storing to VFO (page 20) ----------------------------------------------
Programming Priority Channel (page 20) ------------------------
Memory Channel Programming (pages 20, 21) ---------------
Recalling a Memory Channel (page 20) ------------------------
Changing a Memory Channel (page 20) -----------------------
Construct a Memory List (page 20) --------------------------------
Locking a Memory Channel (page 21) ---------------------------
Restore Factory Memory Programming (page 21) -----------
Restore Factory Setup Settings (page 21) -----------------------
SCAN FUNCTIONS
Program the Scan (Stop) method (pages 16, 22 - 26) -------
- Stop scan at first detected carrier; exit scan -----------------
- Stop scan at detected carrier; resume (5) seconds after
carrier drops. ---------------------------------------------------------------
- Stop scan at detected carrier; wait (5) seconds; resume
scan. --------------------------------------------------------------------------
- Stop scan at detected carrier; resume scan immediately
after carrier drops. -------------------------------------------------------
Scan Memory (pages 16, 22 - 26) -----------------------------------
Program to scan ALL memory channels -------------------------
Program to scan a RANGE memory channels -----------------
With a desired frequency displayed,
Press
STORE
#
3
2
VFO
to store into VFO, or
Press
STORE
#
3
1
PRIO
to store into priority, or
Press
STORE
#
3
3
MEM
for a flashing memory number
indication. Enter a 2-digit number.
From the VFO or Priority mode, Press
3
MEM
,
NUM
*
. Enter 2-
digit memory number. In the memory mode, rotate tuning
wheel or Press
/
for selection.
Store a new channel to old location (erases original
information).
Press and hold
SETUP
D
.
‘A’: Rotate tuning wheel to SETUP #30 (through 39). Press
/
for 0-9 index within a list. Enter a 2-digit memory
channel number at each desired index. Advance the
index, enter the next 2-digit memory channel number until
list is complete. Advance to next Setup number (rotate
wheel) if additional lists are to be programmed.
‘B’: Same as ‘A’, except use SETUPs #40-49.
With the desired memory number displayed, Press
0
LOCK
(lock '
' symbol lights).
With power off, Press and hold
3
MEM
while turning the TR270
power switch on.
With power off, Press and hold
SETUP
D
.
Press and hold
SETUP
D
. Rotate tuning wheel to SETUP #16, 17,
18, or 19 as required.
Press
/
to set for ‘0’, or
Press
/
to set for ‘1’, or
Press
/
to set for ‘2’, or
Press
/
to set for ‘3’.
Press and hold
SETUP
D
.
‘A’: Rotate tuning wheel to #24. Press
/
to set ‘0’.
‘B’: Rotate tuning wheel to #27. Press
/
to set ‘0’.
‘A’: Rotate tuning wheel to #24. Press
/
to set ‘1’.
Rotate tuning wheel to #25. Enter 2-digit start number.
Rotate tuning wheel to #26. Enter 2-digit stop number.
‘B’: Rotate tuning wheel to #27. Press
/
to set ‘1’.
Rotate tuning wheel to #28. Enter 2-digit start number.
Rotate tuning wheel to #29. Enter 2-digit stop number.