Quick Reference Guide, continued 47
Program to scan a List of Memory Channels (pages 24, 25)
Program to scan VFO (pages 16, 17, 25, 26) --------------------
Start Scan (pages 7, 23-26) -------------------------------------------
Stop Scan (pages 7, 23-26) -------------------------------------------
OPERATION WITH REPEATERS
Set Repeater Offsets (pages 27, 28) -------------------------------
CONFIGURE UNIT TO OPERATE AS A REPEATER
(pages 16, 29, 30)
Set for Normal or Repeater Mode (page 16) -------------------
Set repeater mode highpass audio filter On or Off
(pages 19, 30) --------------------------------------------------------------
SUBAUDIBLE TONE
Set Transceiver ‘A’ subaudible tone filter On or Off
(pages 19, 28) -------------------------------------------------------------
Set Receiver ‘B’ subaudible tone filter On or Off
(pages 19, 28, 30) --------------------------------------------------------
Program Subaudible Tone Frequency (pages 28, 30) ------
‘A’: Rotate tuning wheel to #24. Press
/
to set ‘2’.
(construct List in SETUPs #30-39, if necessary) Exit SETUP.
Press and hold
3
MEM
for flashing prompt. Enter desired
list number, 0 - 9 (as programmed in SETUPs #30-39).
‘B’: Rotate tuning wheel to #27. Press
/
to set ‘2’.
(construct List in SETUPs #40-49, if necessary) Exit SETUP.
Press and hold
3
MEM
for flashing prompt. Enter desired
list number, 0 - 9 (as programmed in SETUPs #40-49).
Press and hold
SETUP
D
.
‘A’: Rotate tuning wheel to #20. Enter the START
frequency endpoint (144 - 148 MHz).
Rotate tuning wheel to #21. Enter the STOP
frequency endpoint (144 - 148 MHz).
‘B’: Rotate tuning wheel to #22. Enter the START
frequency endpoint (136 - 174 MHz, 420 - 470 MHz).
Rotate tuning wheel to #23. Enter the STOP
frequency endpoint (136 - 174 MHz, 420 - 470 MHz).
Set the squelch control to quiet the receiver. Press and
hold either
2
VFO
or
3
MEM
, as desired, to start the scan.
During scan, press
1
PRIO
,
2
VFO
or
3
MEM
. For transceiver ‘A’
only, keying PTT also stops the scan.
Press
4
RPT
, to select ‘+’ , ‘-’, or Simplex.
Press and hold
SETUP
D
. Rotate tuning wheel to SETUP #13.
Press
/
to set ‘0’(normal) or ‘1’(repeater).
Press and hold
SETUP
D
. Rotate tuning wheel to SETUP #57.
Press
/
to set ‘0’ (filter off) or ‘1’ (filter on).
Press and hold
SETUP
D
. Rotate tuning wheel to SETUP #59.
Press
/
to set ‘0’ (filter off) or ‘1’ (filter on).
Press and hold
SETUP
D
. Rotate tuning wheel to SETUP #60.
Press
/
to set ‘0’ (filter off) or ‘1’ (filter on).
‘A’: Press
8
CTS
3
rotate tuning wheel or press
/
to
set desired tone frequency.
‘B’: Press
8
CTS
3
rotate tuning wheel or press
/
to
set desired tone frequency (or ‘OFF’ for no tone).