In normal conditions, the range test should yield a distance of approximately
10
metres, or 30 feet
. 5 metres, or 15 feet, is acceptable for shorter range craft that will
operate up to a maximum distance of 5km.
3.3.2 Bind Mode
It is possible to bind the transmitter to the receiver without using the DragonLink
GUI. To do so,
1.
Ensure the receiver is powered
off.
2.
Hold down the
Menu
button on the DragonLink transmitter and turn on the
power.
1.
After the power-on sound is played, continue to hold the
menu
button until the
LED(s) on the transmitter turn
blue
accompanied by
2 beeps
.
2.
Release the
Menu
button.
3.
The transmitter will continue to play
2 beeps
(if the
bind mode
alarm is enabled)
and the LED(s) will
flash blue
to indicate it is in binding mode.
4.
Power on the receiver.
5.
The receiver’s blue and green LEDs should both begin flashing to indicate a
successful bind.
6.
Power off both the receiver and the transmitter to save the binding.
3.3.3 Servo Test
In servo test mode, the DragonLink transmitter will continuously sweep all channels
back and forth from minimum to maximum positions.
1.
Hold down the
Menu
button on the DragonLink transmitter and turn on the
power.
2.
After the power-on sound is played, continue to hold the
menu
button until the
LED(s) on the transmitter turn
yellow
accompanied by
3 beeps
.
3.
Release the
Menu
button.
4.
The transmitter will continue to play
3 beeps
(if the
servo test mode
alarm is
enabled)
and the LED(s) will
flash yellow
to indicate it is in servo test mode.
5.
To exit servo test mode, press the
menu
button.
