ID:
Displays the Transmitter ID (previously set by you) that the receiver is currently
bound to.
Firmware version:
Displays the version of currently applied firmware.
Volt Cal Calue:
This value allows calibration of the DragonLink Voltage Sensor (sold
separately). If you measure the voltage of your flight battery and discover it to be
incorrect, this value, which is a percentage of the sensed voltage, can be adjusted to
correct it.
Rf Band:
Displays the selected RF Band as set on the transmitter prior to binding.
Hardware ID:
This setting tells the receiver which type of receiver it is and as such it
should never need to be changed. This configuration is needed internally for the
firmware to handle pin assignments and configuration. This is normally set once
when first connected to a PC, however it can be changed here if it is inadvertently
set incorrectly.
Set hardware ID:
Confirms the change to the above setting.
Reset hardware to Factory Settings:
Restores all of the configuration to factory
default settings.
3.5.3 Radio Modem
Input / output baud rate (on receiver):
Specifies the baud rate for the Receiver to
use for serial radio modem communication. This must match the baud rate set for
the device(s) attached to the Receiver and on the receiving ground station. It must
also match the Transmitter’s UEXP baud rate, if that connection is to be used on the
receiving end.
