3.3.4 Change Transmitter ID
Before operating the DragonLink system for the first time, the transmitter ID must be
changed as not doing so presents the possibility of interference if another system
with the default ID is used within range.
1.
Hold down the
Menu
button on the DragonLink transmitter and turn on the
power.
2.
After the power-on sound is played, continue to hold the
menu
button until the
LED(s) on the transmitter turn
red
accompanied by
4 beeps
.
3.
Release the
Menu
button.
4.
The transmitter’s LED(s) will
flash red
to indicate the ID has been changed.
5.
To exit ID change mode, you will need to power-cycle the transmitter.
NOTE: You will need to re-bind your receiver(s) after changing the
transmitter ID.
3.3.5 Exit USB Telemetry Mode
After changing the
USB function
setting on the DragonLink transmitter, it will no
longer be possible to configure the transmitter using the USB port and GUI software.
To restore the default USB mode:
1.
Hold down the
Menu
button on the DragonLink transmitter and turn on the
power.
2.
After the power-on sound is played, continue to hold the
menu
button until the
LED(s) on the transmitter turn
white
accompanied by
5 beeps
.
3.
Release the
Menu
button.
4.
The transmitter will play the power up sound and the LED(s) will
flash white
to
indicate the USB mode has been changed.
5.
Power-cycle the transmitter for the change to take effect.
3.3.6 Set Failsafe Channel Positions
When the
Normal
failsafe mode is applied to the DragonLink receiver, it will move all
of the channels to a pre-configured position upon loss of signal.
1.
With the DragonLink transmitter and receiver powered on, check that both the
transmitter and receiver are displaying
blue
LEDs to indicate an active link.
