DPS KDA 864, User Manual

Page: 11 / 57

SOFTWARE DETAILS • PRIMARY DOCKING PORT
1.8
TBOS Protocol Settings
Responder Baud Must match interrogator port setting,
normally 2400.
Responder Parity Must match interrogator port setting,
normally ODD.
Report Satellite Failures When checked, reports satellite failures
in bit 65.
RTS Lead Time Time, in milliseconds, after serial port
RTS handshaking is asserted that data
bits start to be transmitted. Ordinarily
does not have to be changed, but may be
adjusted if communications timing prob-
lems are encountered or delay is needed
for relay keying.
RTS Tail Time Time, in milliseconds, after serial port
data transmission stops that RTS hand-
shaking is cleared. Ordinarily does not
have to be changed, but may be adjusted
if communications timing problems are
encountered or delay is needed for relay
keying (see below).
Relay 8 Response to RTS When checked, on-board relay 8 closes
when RTS is asserted. This may be used
to key an external radio transmitter, etc.
D-SW-709 UM00C.08103
October 22, 2001 www.dpstele.com