Douwe Egberts Cafitesse 600, Operator'S Manual

Page: 12 / 32

12 02.2010
Operation
Adjusting the cup tray position
At installation your Cafitesse system supplier will install the cup tray at a
specific height. If you would like to use different cups, you can change the
vertical position of the cup tray:
1. Open the dispenser door.
2. Press the ON/STANDBY/RESET switch to set the dispenser to
STANDBY mode.
3. Tilt the cup tray upwards and lift it from the cup tray support. (Fig. 17)
4. Move the cup tray position as follows:
a. Use a screw driver to loosen the 2 screws of the cup tray support.
(Fig. 18)
b. To move the cup tray upwards, hold the support on both sides and
push it upwards. (Fig. 19)
c. To move the cup tray downwards (fig. 20):
a. Use one hand to press the notch in the recess of the cup carrier.
This will unlock the current carrier position.
b. Use the other hand to push the support downwards.
d. Use a screwdriver to fasten the 2 screws to secure the cup tray
position. (Fig. 21)
5. Place the cup tray on the support and verify correct position.
Caution:
Do not fasten the screws too tightly.
6. Press the ON/STANDBY/RESET switch again to reactivate the
dispenser.
17
18
19
20
21