Dorner iDrive 3200 Series, Installation, Maintenance & Parts Manual

Page: 6 / 48

Dorner Mfg. Corp. 6 851-702 Rev. A
3200 Series iDrive Belt Conveyors
Installation
Figure 4
Figure 4
Required Tools
• Hex-key wrenches:
- 4 mm, 5 mm
• Level
• Torque wrench
Recommended Installation
Sequence
• Install support stands (see accessory instructions)
• Assemble conveyor (if required)
• Attach mounting brackets to conveyor
• Attach conveyor to stands
• Install return rollers on conveyor (optional)
• Mount gearmotor mounting package (see accessory
instructions)
• Attach guides/accessories (see page 26 through 40 of
“Service Parts” section for details)
Conveyors Up to 13 ft (3962 mm)
No assembly is required. Install mounting brackets and
return rollers. Refer to “Mounting Brackets” on page 7 and
“Return Rollers” on page 8.
Conveyors Longer Than 13 ft
(3962 mm)
Installation Component List:
1. Locate and arrange conveyor sections (Figure
5, item 1) by section labels (Figure 5, item 2) .
Figure 5
Figure 5
2. On tension end of the conveyor, identified by the pinion
locking screw (Figure 6, item 1) , push in head plate
assembly (Figure 6, item 2) : Loosen the pinion locking
screw (Figure 6, item 3) , adjust the pinion torque screw
(Figure 7, item 1) . On both sides of conveyor, loosen
the two tail clamp bolts (Figure 6, item 3) , and push
head plate assembly (Figure 6, item 2) inward.
Figure 6
Figure 6
NOTE
Conveyor MUST be mounted straight, flat and
level within confines of conveyor. Use a level
(Figure 4, item 1) for setup.
1
1 Conveyor frame
2 Section Label
2
2
1
1
3
2