Dorner iDrive 3200 Series, Installation, Maintenance & Parts Manual

Page: 24 / 48

Dorner Mfg. Corp. 24 851-702 Rev. A
3200 Series iDrive Belt Conveyors
Preventive Maintenance and Adjustment
Switch Removal and Replacement
1. Remove belt. (See “Belt Removal for Conveyor Without
Stands” on page 13 or “Belt Removal for Conveyor
With Stands” on page 13.)
2. Remove wear plate (Figure 72, item 1) by removing
plate fastening screws (Figure 72, item 2) on each side
and end of conveyor
Figure 72
Figure 72
3. Disconnect wiring harness connector (Figure
73, item 1) from circuit board wiring connector (Figure
73, item 2) .
Figure 73
Figure 73
4. Remove tie strap (Figure 73, item 3) holding wiring
harness to conveyor frame.
5. Remove two hex head screws (Figure 74, item 1) and
switch assembly (Figure 74, item 2) from conveyor
frame.
Figure 74
Figure 74
6. Replace switch assembly.
7. Reinstall in reverse order of removal.
A
WARNING
Exposed moving parts can cause severe
injury. LOCK OUT POWER before removing
guards or performing maintenance.
1
2
NOTE
Make sure the cord or wires are not kinked or
under any conveyor parts when
reassembling.
1
2
3
2
1