Dorner iDrive 3200 Series, Installation, Maintenance & Parts Manual

Page: 22 / 48

Dorner Mfg. Corp. 22 851-702 Rev. A
3200 Series iDrive Belt Conveyors
Preventive Maintenance and Adjustment
Circuit Board Removal and
Replacement
1. Remove belt. (See “Belt Removal for Conveyor Without
Stands” on page 13 or “Belt Removal for Conveyor
With Stands” on page 13.)
2. Remove wear plate (Figure 66, item 1) by removing
plate fastening screws (Figure 66, item 2) on each side
and end of conveyor
Figure 66
Figure 66
3. Disconnect two wiring harness connectors (Figure
67, item 1) from motor connector (Figure 67, item 2)
and switch wiring connector (Figure 67, item 3) .
Figure 67
Figure 67
4. Remove hex head screw (Figure 68, item 1) , and loosen
hex head screw (Figure 68, item 2) . Remove circuit
board (Figure 68, item 3) from conveyor frame.
Figure 68
Figure 68
5. Replace circuit board.
6. Reinstall in reverse order of removal.
A
WARNING
Exposed moving parts can cause severe
injury. LOCK OUT POWER before removing
guards or performing maintenance.
1
2
NOTE
Make sure the cord or wires are not across
the circuit board when reassembling. Tuck
wires and cable into the frame extrusion.
3
2
1
2
1
3