22
21
C. Basic Use
Remove Harness Straps
from Splitter Plate
Fully loosen harness straps.
Locate splitter plate on
the back of the seat and
unfasten the harness straps.
1.
Pull Harness System
Completely Out of the
Shell and Pad
5.
C-5
Removing Pad for Cleaning
3.
4.
Insert Metal Retainer
Through Shell and Pad
Rotate metal retainer, then
insert retainer up through
the shell and pad.
Locate Buckle’s Metal
Retainer
Remove Pad
Pull pad off the top of
child restraint and remove
pad.
6.
Cleaning Seat Pad
Hand wash pad with warm sudsy water, rinse clean and
air dry. Spot clean the harness straps. Do not use bleach
or other harsh cleaners. Do not dry clean.
Remove Harness’s Metal
Retainer From Shell
Turn the child restraint over.
Use a flathead screwdriver
and lift metal retainer off
plastic tab. Insert metal
retainer through shell and
pad. Repeat for other side.
2.
Replace child restraint pad by reversing order; Starting from
bottom of child restraint, slip pad on shell; pull harness
tightening strap through pad. Wrap pad around the top of shell.
Pull pad around each cup holder and slip pad over the sides of
the restraint.
Install harness system (see section C-6).
Do not use child restraint without the seat
pad. Failure to do this can result in serious
injury or death.
